Sonifex PS-AMPS IP to Speakers Streaming Decoder 1U Rackmount

Sonifex PS-AMPS IP to Speakers Streaming Decoder 1U Rackmount

Model/Product no.: SF-PS-AMPS
Stock status: Please ask for estimated delivery time
Piece

Sonifex PS-AMP IP to Speakers Streaming Decoder

PS-SEND logoWeb icon

The PS-AMP is a freestanding unit which converts an IP audio stream directly to speaker outputs. It is also available in a 1U rack-mount as the PS-AMPS. The PS-AMP has the same feature-set as the PS-PLAY except that there are no individual audio outputs other than the speaker terminals. The PS-AMP uses an integrated 2 x 15W D-class amplifier to deliver audio directly to a pair of connected speakers.

For further information on features please refer to the PS-PLAY.

PS-AMP Screen

PS-AMP, Basic Settings Screen.

Technical Specification For PS-AMP

Analogue Outputs: 2 x speaker connectors (2 each black and red terminals)
1 x ¼ inch (6.35mm) stereo jack headphone socket
Headphones Output: Drives 150mW into 32Ω to 600Ω stereo headphones
Headphone Level  Range: -60dB – 18dB via front panel control knob or optional IR controller
USB Port: 1 x USB A socket
Frequency Response: 20Hz - 20kHz using MP3 at a bit rate of 192kbps and above
GPOs (General Purpose Outputs): 2 x switchable relay contacts (simultaneously switched) controlled from PS-SEND
Serial Port: 1 x 9 way D-type socket, used to send control commands and update firmware
Ethernet Port: 1 x RJ45 socket. Remote control commands can be sent via TCP or UDP as well as firmware updates.
IR Remote Receiver: Remote commands can be sent using optional remote control via built in IR sensor
Speaker Power: 15W per channel into 8ohm @ 10% THD+N
Mains Input: Filtered IEC, 85 - 264VAC, 47 - 63 Hz, 60W max
Fuse Rating: Anti-surge fuse 1A 20 x 5mm
   
Audio Codec Specifications Decoder
G.711 (U Law/A Law 8kHz to 48kHz sampling rate)
WAV (IMA ADPCM+ 16bit PCM uncompressed: 8kHz to 48kHz)
MP3 MPEGv1 Layer 3 (32, 44.1 and 48kHz, CBR +VBR +ABR)
MP3 MPEGv2 Layer 3 (16, 22.05 and 24kHz, CBR +VBR +ABR)
Ogg Vorbis (floor 1)
Supported Network Transport Protocols
RTP - UDP
HTTP - TCP
Raw UDP
Raw TCP
SNMP - traps for remote management
DHCP, BOOTP, IPZator or AUTOIP - Dynamic IP address resolution
SonicIP IP Address readout
   

Physical Specification


Dimensions (Raw):
22cm (W) x 13.7cm (D) x 4.3cm (H)
8.67” (W) x 5.39” (D) x 1.7” (H)

Dimensions (Boxed):
34cm (W) x 27cm (D) x 6cm (H)
13.4” (W) x 10.6” (D) x 2.4” (H)

Weight:
Nett: 0.84kg Gross: 1.64kg
Nett: 1.85lbs Gross: 3.6lbs
 

Product's tags

There are no tags registered.

Mine tags